| Image may be NSFW. Clik here to view.  |
| Pin Diagram of IC HT12E |
HT12E is a 2^12 series encoder IC widely used in remote control and very common among Radio Frequency RF applications. This HT12E IC capable of converting 12 bit Parallel data inputs into serial outputs. These bits are classified into 8 (A0-A7) address bits and 4(AD0-AD3) data bits. Using the address pins we can provide 8 bit security code for secured data transmission between the encoder and the decoder. The encoder and decoder should use the same address and data format. HT12E is capable of operating in a wide Voltage range from 2.4V to 12V and also consists of a built in oscillator.
PIN DESCRIPTION OF IC HT12E:
The pin Description of the IC HT12E was pretty simple to understand with total of 18 pins.
- VDD and VSS: Positive and negative power supply pins.
- OSC1 and OSC2: Input and output pins of the internal oscillator present inside the IC.
- TE: This pin is used for enabling the transmission, a low signal in this pin will enable the transission of data bits.
- A0 - A7: These are the input address pins used for secured transmission of this data. These pinns can be connected to VSS or left open.
- AD0 - AD3: This pins are feeding data into the the IC. These pins may be connected to VSS or may be left open for sending LOW or HIGH bits to the encoder.
- DOUT: The output of the encoder can be obtained through this pin and can be connected to the RF transmitter.
WORKING OF IC HT12E:
| Image may be NSFW. Clik here to view.  |
| Timing Diagram of HT12E |
HT12E starts working with a low signal on the TE pin. After receiving a low signal the HT12E starts the transmission of 4 data bits as shown in the timing diagram above. And the output cycle will repeats based on the status of the TE pin in the IC. If the TE pin retains the low signal the cycle repeats as long as the low signal in the TE pin exists. The encoder IC will be in standby mode if the TE pin is disabled and thus the status of this pin was necessary for encoding process. The address of these bits can be set through A0 - A7 and the same scheme should be used in decoders to retrieve the signal bits.
PRACTICAL CIRCUIT OF HT12E:
| Image may be NSFW. Clik here to view.  |
| Practical Application Circuit |
The above diagram shows the practical set up of the HT12E encoder IC for better understanding on the working.
Share this IC working with others through social sites if you like. Feel free to comment and post your queries regarding this post we are happy to assist you. Thank you for visiting come back again for more articles, Enjoy Electronics.
Image may be NSFW.
Clik here to view.
Image may be NSFW.
Clik here to view.Image may be NSFW.
Clik here to view.Image may be NSFW.
Clik here to view.Image may be NSFW.
Clik here to view.
Image may be NSFW.Clik here to view.
Image may be NSFW.Clik here to view.
Image may be NSFW.Clik here to view.
Image may be NSFW.Clik here to view.
Image may be NSFW.Clik here to view.
Clik here to view.
